Looks good are the arches having moulds for fibreglass panels?
Sent from my iPhone using Tapatalk
Looks good are the arches having moulds for fibreglass panels?
Sent from my iPhone using Tapatalk
More work on the bumper and front wings
Had a look at the rear moulds on the car
Using "CAD"
Have removed the loom from the saloon and labelled it up, stripped out the unnecessaries and started to label up the honda loom
Fitted bootlid again with seal and it seems to be sitting well just need to work out where to put pins, to keep original holes or not
Checking a few bits and bobs before finishing the cross brace
Put both seats in to get an idea of space inside, passenger side just sitting on floor with no rails thats why its so low
Made a start on the dash with some 'CAD'
Bodywork's gonna look special & unique I imagine.
At this stage I would advise a better steering wheel column / angle and getting the gear shifter in towards the driver more, as if you leave it you'll struggle to improve things once all the dash is back in.
I always thought the shifter position was strange in the Civic, it's not until you actually drive one you realise it actually feels very nice where it is as it's nice and close to the steering wheel.
Nick
I can't agree with the steering wheel position / angle