Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: issue with my heater matrix in my c20let nova not blowing hot air but gets up to temp

  1. #1
    Newbie
    Join Date
    Jun 2010
    Location
    bathgate
    Posts
    36
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default issue with my heater matrix in my c20let nova not blowing hot air but gets up to temp

    A have put a hose on the matrix to male sure it wasn't blocked and made sure the water pipes were on right any other issues that could coz it to blow cold and no get hot

  2. #2
    Moderator Moderator conza123's Avatar
    Join Date
    Dec 2011
    Location
    Sandwich kent
    Posts
    2,339
    Post Thanks / Like
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)

    Default

    Are both heAter hoses hot when up to temp? As u mite have a air lock in there or its blocked

  3. #3
    User
    Join Date
    Feb 2014
    Location
    Selby
    Posts
    996
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Cable that goes from heater knob snapped off heater?

  4. #4
    Newbie
    Join Date
    Jun 2010
    Location
    bathgate
    Posts
    36
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Both hoses are hot and cable is fine was workin fine when the Sr Engine was in the car

  5. #5
    Moderator Moderator conza123's Avatar
    Join Date
    Dec 2011
    Location
    Sandwich kent
    Posts
    2,339
    Post Thanks / Like
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)

    Default

    Just double check the cables are moving heater box end if there fine then I expect u have a blocked heater matrix

  6. #6
    User
    Join Date
    Feb 2014
    Location
    Selby
    Posts
    996
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Try putting hose pipe on steady through the matrix with the pipes off to prove it's clear.

  7. #7
    Newbie
    Join Date
    Jun 2010
    Location
    bathgate
    Posts
    36
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    A put a hose on the matrix and is clear a think it may have a air lock some where how would a get rid of that

  8. #8
    Moderator Moderator conza123's Avatar
    Join Date
    Dec 2011
    Location
    Sandwich kent
    Posts
    2,339
    Post Thanks / Like
    Mentioned
    2 Post(s)
    Tagged
    0 Thread(s)

    Default

    Start the car when it's cold with cap off let it warm up a tad then pull the passenger side heater matrix hose off u mite get covered in antifreeze but should shift the airlock, that's what I had to do in my 1300 after I fitted a new rad

  9. #9
    User
    Join Date
    Feb 2014
    Location
    Selby
    Posts
    996
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Or squeeze the radiator hoses by hand to try pump the air out

  10. #10
    Newbie
    Join Date
    Jun 2010
    Location
    bathgate
    Posts
    36
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Done everything ever body has said and checked over everything and still no heat

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •