Apologies its been a while since my lat update, life's been busy!
Got my seat mounts so started looking at seating positions. I had wanted to sit the seats as far back as possible for better weight distribution but it turns out it is now a necessity as with them in the normal nova position its too cramped due to the bulkhead being moved back a few inches. So some pics...
Attention then turned to working on the floor. I tidied up where the box rails met the bulkhead...
Started to make the piece I needed...
Then made the floor piece (1st section, will be another continuation under the seats)...
And together...
Then a piece on the other side and complete!
Rinse, wash, repeat and both sides done...
Thanks for looking.