Rear chassis legs

[Southie]

Bolloocks cut them you'll be making better quality materials than the originals

[bazil]

You stick to photoshop mate and never ever do bodywork

If you involved a grinder to remove any of the sections it cant be reproduced in its original form

[Edd]

You can buy the spring cup as a separate pattern part from mmDronton

[bazil]

All the better

In fact the only section that would really be needed would be the long thin section,

[Southie]

You stick to photoshop mate and never ever do bodywork

If you involved a grinder to remove any of the sections it cant be reproduced in its original form

You tart

I never said grind, I ain't Milly Cirus

[bazil]

Go on geez a twerk

Ah fcuk, forgot about the beam mounting point too

[Southie]

Go on geez a twerk

Sorry bazza for filling the wanted thread up with nonsense btw... Bazil av'it:

[bazzap8389]

Dinna worry about it all good banter

any idea what the turn around for 1 would be if the place can replicate them? The back end of my car is getting started in early January I'm so prepared

[bazil]

If required I could strip the legs to daves requirements and send them after xmas,

What im thinking is that the thick parts ( spring cups, axle mounts, inner sill join area ) dont need to be replicated as they should be ok, leaving the actual leg bare, easier to copy and cheaper too?

[bazil]

You must spread some Reputation around before giving it to Southie again.