Somewhere on this thread someone mentioned about using corsa bits on nova to wide track it a little bit ? anyone done this and what could be used, rear axle with mounts modified ? arms/tie arms/ARB, steering rack, shafts ?
Just spotted this thread. Looks great mate
cheers, need to pull my finger out on nova now sick of it sat there untouched, engines out and i may use xe out of corsa and bits off that to get the nova finished, i also got a full saab turbo lump with everything, i just need to see for myself how much work it would be to put in a nova or corsa even if i dont do it.
Put the saab lump in the nova
did you make the hinges for your doors yourself?
il be checking it out this week, nova front end stripped and up in the air ready to check it out see how much needs doing and if i feel i can do it r not, cant find any done so thats worrying or if its even worth it or just do the easy route and xe it with R1 set up i already have.
hinges was from the old doors with spreader plate welded on
Ah right, well at least you have an xe you know you can basically drop in if you cant get the saab engine in.
ok cheers, ill have to see if i can get some hinges aswell then
Went for the easy route and put XE in , probably fitting the R1 carbs to it too
Needs painting and few bits but getting there now
Not sure on colour tested a few in areas and not keen on any apart from matte black, some look rubbish, but seen a couple look good mainly ExTrEmeOC's bad boy.
This looks nice in sun, but i dont think i would do full car in it
and the other
Come on Keith this not finishe yet?? Haha
Looks goo mate defo track prepared aswell can't wait to see it out!!