Right people i know this question has been asked time and time again and from the search button ive found this information:
- Black is positive when “key on”.
- Brown is ground.
- Green is for coil to tachometer.
- Red/bleu (bigger diameter) is the positive one for the electrical fuel pump (when starting with a carburetted engine this wire is not in the vehicle).
- Bleu/green is oil pressure.
- Black/yellow is oil level.
- Red/black is starter relay.
- Bleu/red is for positive when “key on”, this one is for the ICU.
The question im asking is where i will i find where to connect the wires from the c16se loom onto the 1.2 spi loom?
I see that mowgli was going to make an article back in 09 but must not have got round to it.
Thanks in advance and Rep to all that help
(P.s im helping a mate out as i would have ditched the injection and fitted carbs )