Buy a centre punch.
Printable View
Buy a centre punch.
im look at a set from toolstation right now, want some before i start messing about mounting the seats
bough a bench vice, only a small one but mehhhh
http://i475.photobucket.com/albums/r...t/SAM_1026.jpg
started bolting some body panels back on to check my paint lines & line up where the bonnet pins are going
http://i475.photobucket.com/albums/r...SAM_1027-1.jpg
now is it normall to see this gap under the bumper
http://i475.photobucket.com/albums/r...SAM_1028-1.jpg
im going to remove the bumper irion and hold it on with bonnet pins, and leave the 2 screws either side to make sure its lined up half right atless, also thinking about getting a square licence plate for the corner and drilling holes in the bumper to get more air on the rad
gap is normal mate
Instead of getting a square plate, get a stick on one and stick it on the bottom valance either in the middle or to one side.
i like that idea,Quote:
Originally Posted by Liam
today i done this
http://i475.photobucket.com/albums/r...t/DSC00020.jpg
http://i475.photobucket.com/albums/r...t/DSC00021.jpg
which has resulted in the bonnet looking like this
http://i475.photobucket.com/albums/r...t/DSC00025.jpg
:roll: whoopsieeeee
this is where Ive placed the front bonnet pins
http://i475.photobucket.com/albums/r...t/DSC00026.jpg
wish i placed them further into the corners like every one else, that way they would have been square with the top ones I'm also putting in (isn't hindsight a lovely thing :mad:) never mind this is only a stand in , eventually i will swap it for a fiberglass one and properly use locking bonnet pins
also im going to buy panel beating hammer to flatted out some of the creases in the bonnet and then wrap it to make it look a bit less battered
sorry, but what the hell did you take the bonnet frame off with, a spade?
bolster lol
it was full of dinks and dent when i got it back anyway so wasn't being to carefully tbh
f lol mowgli