lovin the seats ! see you @pv 08 then yea
lovin the seats ! see you @pv 08 then yea
cant wait to see what it will be like when its finished..
right fillerd the wing up today.. didnt need that much tbh.
seems to have dried now, altho i forgot to get somemore wet n dry, so i shall be going tomorrow for it..
while i was waitin for it to dry i did these,
Still not 100% the cars staying red going to look at the color charts tomorrow and see if any take my fancy.
right i wasnt totaly happy with the filler on the wing, and as i couldnt sleep last nite i decided to remove it all..
soo i got'to rubbing and about alf an hour later it was gone.. damn my arm hurts..
heres a few pics..
now this leaves me with a problem.. theres still dents were the filler was, well i got my trusty hammer out and flat block of wood, and i gently tapped the dents out and now its nigh on perfect :D
heres pics of were the dents was, what should i use to protect the bare metal? etch/zinc primer?
should be in primer by next week or even painted..
Martin
Halfords do Zinc primer.
Either etch or zinc as I think they are the same thing.
Looking good.
And yeah protect the bare metal, as even moisture in the air will start rusting it.
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
deffinatly etch primer , but not alot , only a light over spray / dust
Posting Permissions
Reply With Quote
