Well the OE belt is looped round the Chrome raile.
My harnesses have the Carabena type clip thingy, so probably not the safest idea !
Well the OE belt is looped round the Chrome raile.
My harnesses have the Carabena type clip thingy, so probably not the safest idea !
The problem is the harness clip will slide about on the rail, plus 3 point seat belts have different forces working on them than 4 point harnesses.Originally Posted by Last Of The Nova SR'S
If its safe enough for the OE belt, i dont see a problem. However, i wouldnt do it either way
valid pointlike i said tho, i wouldnt do it anyway, mine are all bolted down uber tight
so i'm presuming your using the Chromed Loop thingy bolt ?
the bolt hole yes
don't happen to have pictures of both your lap belt mounting points ? just out of interest !
from sitting in the drivers seat:
Remove seatbelt locking mechanism (on your left) this exposes a metal bracket, bolt one side of the harness in there.
Remove the lower steel loop (on your right, attached to sylll) completly out of car, this exposes another mounting point, bolt the other side in there.
Viola.
I don't quite know what everyone is on about !
I just put the harnesses in without having to remove anything from the car.
On the chrome loop thingy, i just removed the cap. replaced the bolt with an eyelet bolt and clipped the lapbelt onto that ! Only thing i had to do was remove the seat from the rails, and re-install it !
Job done !
Posting Permissions
Reply With Quote