House's ITB XE build and re-build
New tank modified ready for install
Added AN6 feed and returns and also a drain plug as it's always a pain to drain the tank if you need to.
I couldn't find an original nova level sensor so decided to go with one of the solid float type from CBS, as usual, needed some work to get it in and working
Last edited by House; 01-10-19 at 02:28 PM.
Fancy!
Nice welding
What time do you reckon you’ll finish at Snetterton as it’s my home track and I’d love to come an have a nosey round this car
Well I'm hoping we'll be there all day mate, don't tend to pack up too early unless there are issues or we're out of fuel (although Snet has fuel so that won't be issue) so likelihood is we'll still be there at 4.30-5 or whenever the day ends.Originally Posted by rich a
All Ben's work!! I make the bits, he welds them together!!
Few little updates before Cadwell on Sunday.
Popped over to see Mitch at Pro-line and we sorted the plumbing for the swirl pot
Put less than 2 litres in the tank and it fired up and ran which is mega, just need to re-set the level sender settings and we're done.
Added these residual pressure valves to help prevent pad knock back
One for the front brakes right near the M/c, as we think the issue is up front. Also added one for the rear brakes too. Both hold 2psi in the line to prevent the fluid from draining back and allowing the pistons to retract. Time will tell if this is successful.
All set for tomorrow!!!
Look forward to the videos.
Nick
Scared
It is smashing it down
Got a few videos but it is properly terrifying.
Posting Permissions
Reply With Quote
