I've finally started to get my act together with the welding, I started to get the chassis strengthening plates welded in after a bit of jiggery pokery to get them to fit nicely.
You can see that the front nearside lower suspension plates are in, as they are on the drivers side, the nearside front chassis rail plate has also been added along with the reinforcing plate for the front cross member.
As an aside you can just about make out the 'Cree' Led Headlight stuck on top of my welding helmet, I got pished off seeing only the workshop lights reflecting off the inside of the screen, so now I can turn them off and still see where I'm starting to weld, works very well so that's a result
Done the strut tops as well, it is tricky doing a continual weld on these because their profile doesn't match the standard strut tops, having said that I think there is enough weld there to hold them in place over even the roughest airfield single venue.
Place reinforcing plate in position...
Cut out in order to accomodate the adjustable top mounts...
Weld...
Need to do some tidying up before slapping on some etch primer to try and keep the tin worm at bay.