As above anyone know how this is done. I have tried threaded rod with nuts and washers with no joy
Cheers Richard
As above anyone know how this is done. I have tried threaded rod with nuts and washers with no joy
Cheers Richard
Just done mine with poly bushes. All I did is use plenty of lube and sat the bush inside using a socket the same size hammer in job done.
^^^ same as above plenty of lube and and some good action with your hammer shaft and she will be sorted
Just saw them in half
That's the problem these are rubber and one piece no hope of hammering them in.
Could have a word with Ratty. He pressed mine out. Also... answer your text!
NovalutionGSi - Donkey Kong In a Go-Kart
Wd40 and a vice?
This looks quite a good way of installing bushes:
http://www.suspension.com/blog/how-t...thout-a-press/
MG no need for any of this; angle grind one side off with a cutting disk & push out.
New bush; same 1MM cutting disk cut the middle of the bush creating 2 halves.
10 min cake mode