Eh how do you do a written exam on machining? Surely a practical assessment would be betterOriginally Posted by ShawnAzzopardi
Eh how do you do a written exam on machining? Surely a practical assessment would be better
****ing gyppos have decided to set up camp on grass dead opposite our house. Had to bollock our lass for filling their water barrel up when they came knocking as well. Ought to have pissed in it, dirty thieving *******s
lots of loud music & lights... annoy them..
F!@$ing royal fail not leaving my parcel with neighbour as requested now gotta wait until wednesday to have it redelivered! Really annoyed as wanted to get nova running!
Finding this, my own doing really as I knew about the noise for a while :/ 90% sure the cam has had it as well witch will be a nice waste of £210
Criminal damage case with police about my idiot neighbours, they're refusing to pay for the damages so it'll be court and probably thrown out so end with nothing.
Basically name the entire diagram with parts, and calculating spindle speeds and a load of bollocks.
Why do people weld in a new rear arch without sorting the inner arch, now I need to take the outer arch of to do the inner properly, I'm tired of finding Bodges.
WTF happened there?!?! looks like the cam has spun and ground out the finger.Finding this, my own doing really as I knew about the noise for a while :/ 90% sure the cam has had it as well witch will be a nice waste of £210
I'd get the cam lobed polished up and go again with some nice gloopy oil..... Worst case, it happens again, best case it runs fine
Those rockers be sh1t. Weakest part of any 8V.
Posting Permissions
Reply With Quote
