Spaceframed SR20DET RWD Nova

[The Simps]

I need to extend the back to take account of the seats being further back and thus changing where my head will be so I need the 2 new side pieces coming off the main hoop then a 45deg bend towards the rear turrets. These then need joining with the roof bar where the 45 is. Whether the X is needed, probably not I guess as it should be strong enough, does kinda finish it off tho.

Whats the best way to remove the welding splatter without hitting the grinder on the welds? I've tried using a normal wire wheel attached on the grinder but didn't work. Is it the twisted wire wheel I need to do it?

Might swell change title here too yeah, cheers.

[The Simps]

I think it will be strong enough

For 600BHP

Perfect! Plenty of room for a V8 lump down the line....

[Benn]

Ah i think i get ya. The x will look the great yes and work well in the set up..

You could try and 80grit lose flatter wheel. That or a belt sander... Just to do the spots of splatter...
even a twisted wire wheel i dont think/have found will more splatter...

What as the title again? i'm at work so dont have MIG open..

[The Simps]

Spaceframed SR20DET RWD Nova please Benn, thanks

[millworm]

looking good mate, looking forward to seeing the finished article

[The Simps]

While I wait for an opportunity to go get my tubing and some sheet metal Ive just been working with the cardboard and making up the panel templates, such a tedious job but I'm getting there, slowly!












Black felt tip lines are where I will add bead lines to the sheet metal.

[Benn]

They look good, will look great in metal.

[Andy]

Great work.
i see those panels and think of the crystal maze

[The Simps]

Cheers guys!

When I look at it it reminds me of one of these....

[nova_niek]

Cardboard Aided Design is the way forward!