is this an ok method for attaching intake tubes to flanges, for custom inlet manifolds, strengthwise ?
anyone tried this before ?
is this an ok method for attaching intake tubes to flanges, for custom inlet manifolds, strengthwise ?
anyone tried this before ?
you can get alloy wire for migwelders
^^^ did you just read that? what a idiot ^^^
PROJECT 2 FAST 2 FAT clicky
''lifes what happens, while your busy making plans''
Hello,
It can be done but i wouldn't recomend as you wont get proper penetration in the weld. And there wouldnt be alot of strength. I would just get a proper welder to do it for you.
Idealy you need a stick welder (tig) so its done properly.
I did a few rocker covers with an-8 fittings for catch tanks ect with a blow torch and rods but it was no where as good as when i got my tig welder.
but its up to you !