First up was an mot as their wasnt much left on the car as Martin had sorned over winter and only taxed it so I could test drive. I wouldnt usually buy a car with this little test left but after a good look round I didnt think it would need much. I then booked it in with work for a test.....
Bit of a pain to actually get it onto a ramp at the front with how low it is but I just jacked it under the tie bar bracket then slid the lift arm under with some custom padding to ensure It wouldnt mark the mint painted underside! Rear is a lot easier just going under the end of the beam either side. For anyone having similar issues the 3m fastcut mop head pads worked a treat on the lift arms as seen here below. Although Its a crap pic the JP exhaust system is a true work of art! ........
Thankfully No issues were found during the mot.... Steering rack inner tie rod ends have a little play but these were only advised and will be replaced shortly. Since then Ive enjoyed putting some miles on it but have also done a little more work too....
More to follow.......







Reply With Quote














