Should come out then. Can you not guage which one it is from the centre of the clutch.
Should come out then. Can you not guage which one it is from the centre of the clutch.
yeah I think its 1st cog just looked in an astra manual and that shows my type of box will have a look tomorrow and see. Ive read that the shafts are very tight will a slide hammer work ok ?
Front one I think...
That is the F10 box on the Sport, had to take the cluster out on mine as it is a SCCR cluster
cheers for pic
Take a photo of the box with end plate removed but it's the input shaft should be near the top and inline with the shaft through the clutch there is a clip then a bolt Allen key I think that you remove then get a longer bolt the same thread thread that into the shaft and a pair of grips pull the shaft out that after you clip the clutch obvs
Slide hammer can be used if you are gentle. You do get a small one in the proper removal kit.
will take a pic thanks for help so far everyone
Ok big cog bottom left can just see the bolt set back in the photo
Cheers mate