My Projects thread

[scott.parker]

Wow, didn't see that updates coming..

Shame beasty broke it, but nice to know the engine is in good hands.

[Lee H]

I'm not sure that nut under the RJ at the gearbox end is going to work with an f28 (assuming there is one as hard to tell on the picture). Mine was similar and I had to drill and tap the linkage to bolt it to instead as it is so close to the gearbox.

[Benn]

I would be glad to help as you have always helped me as and where's needed. I didn't actually realise you can run a flat fly with f28?? I have both so no biggy if flat fly is best.

Nick.

Cheers and yea, sure you use the F28 cover and the F20 plate, someone will know for sure. I just told them what i was running when i ordered it..

[dan16v]

I'm not sure that nut under the RJ at the gearbox end is going to work with an f28 (assuming there is one as hard to tell on the picture). Mine was similar and I had to drill and tap the linkage to bolt it to instead as it is so close to the gearbox.

When i made them Lee i put a slight bend upwards so the nut cleared the box casing.

[dan16v]

also may need to trim the thread on the push rod rose joints

[Lee H]

I would run the pot flywheel as then you can run a LET cover plate which is stronger than an XE one. XE flat fly and cover slipped like mad on mine with just phase 2 (so did a stock LET setup as well though tbh).

[peester]

im sure with lots of boost, its better to have the slightly heavier pot type fly; keep momentum rather than gaining it a bit too quickly perhaps with the flat type.. if it is weaker?

[Edd]

Cheers Edd, your pal made it up and has assured me it will be fine as he's made many that have no issues working. However if that is the case it's no problem misalignment washers don't cost much in fact sure I have some somewere will have to take a look!

Nick.

If Grant said it will be ok it probably will be mate, mine is with a F13 so totally different really

[matthew172]

looking good big lad

[Benn]

I would run the pot flywheel as then you can run a LET cover plate which is stronger than an XE one. XE flat fly and cover slipped like mad on mine with just phase 2 (so did a stock LET setup as well though tbh).

I Run it and its been ok so far, i dont do drag stuff maybe thats why it gives up? I have a "uprated" clutch no clue if it will help... Seems ok.