X14xe into nova wiring help

[Nova2013]

Ive recently put a x14xe (one without the powersteering pump)out of a late corsa b sri into my nova with a digi dash and im having problems with the wiring.
I have got it as far as turning over but left with 9 pin pug and unsure where to connect everything. Green wire from plug is rev counter, red with blue needs to be have +12v and brown with yellow is ecu warning light.
Also i believe the early x14xes dont have imobiler built in is this true? as i dont have a obd plug or any other plugs for transponder etc.
Any wiring diagrams and pictures much appreciated
Help.....

[meritlover]

hello and welcome....

[Nova2013]

Hi there, meritlover. Any ideas on my small block conversion? Im pulling my hair out. . there lots of useful tips on here but unfortunately not the same problems as mine.

[chrisd1986]

here is the wiring diagram you need to get it running, if it wont start you may have to get a ecu with the transponder and ignition ring

[Nova2013]

Thanks for the diagram chris. Is there a difference between the late corsa b sri ecu and the sport one (does the sri ecu have an imobiliser)? as on the loom i have there isnt any other plugs to connect the transponder. Or is than incorperated through the 9 pin plug?

[chrisd1986]

it has to be wired in seperate as it would be further on in the corsas loom behind the dash as you can see the diagram shows you how to wire the immob pick up into the loom

[Nova2013]

Ahh ive got you now. trip to the scrappys again . are the vss's coded aswell?

[chrisd1986]

ive got a af type for mine but there are a couple of different ones i dont know what the difference is but i got mine of somone who was using it on his x16xe conversion. are you running standard clocks or a digidash?

[johnd]

mine was on the car originally its aa. not sure if that makes a difference

[chrisd1986]

tbh i think you can wire in the standard digidash one as long as the ecu is getting a pulse otherwise it will cut outwhen you stop at traffic lights etc