Benn's on going build

[Benn]

Yes you should.

[MK999]

Have to find your car and put a face to the car

Just don't leave smudgy face prints when you do.

[novalew]

Just don't leave smudgy face prints when you do.

I will do my best

[BRoadGhost]

It's good that the joint's holding up; as well it should

You could find a straight arm to improve that conversion.

[scott.parker]

Yeah you would benefit from using a zx wiper arm, sorry I didn't bother to try explain more when you have asked about these set ups before, I didn't realise you were trying to use it fixed tight upto the scuttle..

[Benn]

It's good that the joint's holding up; as well it should

You could find a straight arm to improve that conversion.

Yeah, i keep testing it hard and harder corning. I just dont like the thought it might brake again.. Stops me really enjoying it as there is the worry...
I have been thinking about a straight arm... Making one shouldn't be to hard....

Yeah you would benefit from using a zx wiper arm, sorry I didn't bother to try explain more when you have asked about these set ups before, I didn't realise you were trying to use it fixed tight upto the scuttle..

Finf a ZX might be tricky.. If i cut and weld it i think i could get it straight enough and dont worry, yours is mounted the same isnt it?

[SimonTW]

Benn, what length is the arm from spindle to the wiper mounting point? I have a straight wiper arm that may be of use!

[Benn]

It's a Nova arm... Thank you, but this is only really a stop gap. I'd like both wipers on really... So dont really wanna spend out on this set up.

[Benn]

Took the sunroof cassette out today.



Ready to remove the roof skin, you can see why i'm doing this...



Then collected these... Both GM panels. Big huge thanks to Jeffrey.

Roof skin.



New bonnet.



Best cut the roof off now....

[pie]

brave man benn