Very cool!!!!!!!
Very cool!!!!!!!
Thank you AmandaOriginally Posted by Yorkie
Well I had an issue with the one of the old shafts, it was out of line from being welded (sleeve wasn't tight enough) so I got the local engineer to machine me a new sleeve and some shafts and I welded them together making sure it was nice and true this time.
New above
Not bad for an old boy!
Dan
top work looking really good matewill have to get the lincoln meets going again get loads of us out like the old times
Thank you but I didn't think you wanted to be part of the Nova culture anymore?top work looking really good mate
still into them dude
Well just been to leeds to collect these very clean seats
No rips, no burns, all trim intact and have only covered 22k, I would say the rears have never been used looking at them. Just need the door cards now
Dan
Would those seats be anything to do with our fone call mr ball?
No, I have another set in worse condition that I want you to cut up. These ones are my minters!
Well today I fitted the OS brake disc and caliper,
No pads fitted as I haven't got any yet
I made a front pipe which slots over the down/up pipe and joins the ashley system in nicely.
I removed the standard rolled tip and made this out of come scrap from work,
Helps to keep the standard look in my opinion,
I need a two and a half clamp and a two and a quarter clamp now and a couple of rubbers then that's done.
While the back end was up I also set the hand brake up. Works a treat now
Getting there as they say!
Dan
Posting Permissions
Reply With Quote
