Looks great, fuel gauge is a lil... Hhhmm will the dash one not work at all?
I'll have to come take pics of it at Combe...
Looks great, fuel gauge is a lil... Hhhmm will the dash one not work at all?
I'll have to come take pics of it at Combe...
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
The VX220 one works but reads in reverse. Had about £30 in the tank and it said refill. So after burning some fuel it would read 24l or 17l etc.so i had no idea! I guess i could have put a resistor in the circuit? Or found a way of getting the signal....but i fail massively at electrics! So this will have to do.
Aye, come on over and get some pics. Be good to put a name to the face!
My Rebuild
They're over there with their new toys. Someone brought them in. No idea who bought them though.....
Will find out later when the Mrs asks where the **** the washing pole isOriginally Posted by Pistol Pete
I'd have changed the sticker on it to read the over way...The VX220 one works but reads in reverse. Had about £30 in the tank and it said refill. So after burning some fuel it would read 24l or 17l etc.
Aye, come on over and get some pics. Be good to put a name to the face!
And yeah yeah, see you there.
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
Its digital read out on the VX220..
My Rebuild
They're over there with their new toys. Someone brought them in. No idea who bought them though.....
Very nice that! well done.
David.
Team Griffin Nova 2.8 v6, 10.9@124mph santa pod 2012,
UK's Quickest N/A Nitrous FWD
Been busy putting miles on it! Just over 400 now. Few little bits of tinkering along the way. as to be expected.
Got another bit of bling for it the other week...
[IMG][/IMG]
My Rebuild
They're over there with their new toys. Someone brought them in. No idea who bought them though.....
Got round to fitting the side skirts yesterday. Well, one side
Didnt have them as standard, so no studs for the white clips. Just tiger seal them on i thought. Not enough surface for the sealant to adhere to. Had to figure out a way to fit the clips in the right place!
Cue me doing my usual measure 20 thousand times, various methods to check etc etc
Once i was happy i could drill holes in my nice fresh paint work!!
I will post a thread in the articles section with all my measurements. Hopefully it will make it easier for some of you.
Pics.... (off my phone. Didnt anticipate getting this far so didnt have my camera with me!)
Various scribble marks...
Measured and repeated along the sill...
First one on..
Done!
And fitted! G clamp is to hold the upper part of the fin. Had to tiger seal this part.
My Rebuild
They're over there with their new toys. Someone brought them in. No idea who bought them though.....
Nice work on the skirts dude.
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
D'oh I was hoping the clips would be possible to tigerseal on - just not enough of it touching the bodywork to stick on well then? Nice work, measurements will be a useful addition to the Articles section
Posting Permissions
Reply With Quote
