1/4 Mile Times-Add yours

[gunny]

I managed a 13.4 @ 104mph with the clutch still slipping and one of the rear drums sticking on quite bad O.o

[brucer]

Cheers for the tips Mr Dixon, running 10 psi and doing 2nd gear burn outs saw me launching like a ****ing demon

TOTB next year me thinks.

i saw a few of your runs on the sunday and you were getting great starts.

if you havnt mentioned already, what spec is your engine?

[Hobbit]

Hobbit what was your 0-60ft time?

Consistant 1.9's

i saw a few of your runs on the sunday and you were getting great starts.

if you havnt mentioned already, what spec is your engine?

Cheers, z32se bottom end, gas flowed c25xe heads, c25xe inlet and ecu. F20 with Quaife ATB and equal length shafts.

[david dixon]

Consistant 1.9's



Cheers, z32se bottom end, gas flowed c25xe heads, c25xe inlet and ecu. F20 with Quaife ATB and equal length shafts.

Good engine
There's some 12's in that mate.

[Hobbit]

Working on a spread sheet so all this info is more usable...



only got to page 15 so far but getting there

[womble sri]

Consistant 1.9's

That's impressive, my 13.21 had a shocking 2.37 60ft time I reckon with some slicks and practise I should be able to break into 12's

[Hobbit]

easily I'm only 1 tenth off a 1.8, guessing that tenth will be hard to get though.

[Adam]

Sub 2.0sec 60ft, nice!

[david dixon]

easily I'm only 1 tenth off a 1.8, guessing that tenth will be hard to get though.

It is hard mate, we've been after one for a while, we keep getting 1.900's though! just keep at it and you'll get there in the end.

[Hobbit]

My best was a 1.9135, I didn't realise that was good until Nobby pointed it out over Facebook.