quaife straight cut box into the nova

[ocdstigy]

Nar, would only do a nova and TBH looking back i loved my old one. Well I say loved it, I loved the look of it just not everything it became!

Was that the red let?

[matthew172]

Nar, would only do a nova and TBH looking back i loved my old one. Well I say loved it, I loved the look of it just not everything it became!

well my advice is buy a nova and spunk some of your excess cash on it

[Nick J]

well my advice is buy a nova and spunk some of your excess cash on it

Sounds like a plan Rick!

[Rick Draper]

well my advice is buy a nova and spunk some of your excess cash on it

LOL Nar will give that a miss!

[matthew172]

well ive decided to go with eaqual length shaft setup and grp a hubs as im unsure the cvs will cope if i use the 22spline nova gte shafts, knuckles are currentley away being machined for the bigger bearings so hope to have them back soon

also thanks to brucer for the shaft that mates up to the dummy shaft

pic of shafts

[scott.parker]

Im still not convinced it make much difference if you have a good clutch and diff, as i see it as another joint means anorther weakness?

But big block/shafts are a better option IMO.

Scott

[Benn]

I found it took almost all sideways pull away when booting it.

[Adam]

Im still not convinced it make much difference if you have a good clutch and diff, as i see it as another joint means anorther weakness?

But big block/shafts are a better option IMO.

Scott

Its a solid straight splined bar though, so hardly a weakness imo. Its not like your chucking an extra cv joint into the drivetrain.

[matthew172]

well ive got shafts painted and built up now


ecu has arrived too


and my new hubs have also arrived, so much stronger when there un machined, pictured beside a machined one that was on the car previously

[Rick Draper]

Looking mega chief, mega.

When should it run?