i loved all the bits just scattered around the peugeot boot and floor, its like a spares shop in there, if ever you broke down i reckon he would have the bit in there somewhereOriginally Posted by Gareth_C
i loved all the bits just scattered around the peugeot boot and floor, its like a spares shop in there, if ever you broke down i reckon he would have the bit in there somewhere
Your right there mate
What events will you be using the car for? Any idea of a target date for its first outing? or is it a case of when its ready its ready kind of thing.
Still tho 244bhp in a little car like that is good and will be surprising plus leaves you room to improve if you think you need to in the future.
mike
Last edited by nova_mike; 13-09-11 at 11:10 PM.
Cheers mike. It will be out at the start of next year hopefully at the fast show at Santa poD.
Looking good mate! as yours is coming together mine is coming apart
Like that clutch and flywheel, thought you was sticking to single plate? if i have the money i might be changing that on mine as well for 5.25"
Im looking forward to seeing at the fast show! i shall be there and hopefully quicker as i got beaten by a pug that pulled a 12.47!
Cheers mate. Why is yours coming to bits? I bought that setup baecause the price difference wasnt much and the option was dangled in front of me. Why a 5.25"?Looking good mate! as yours is coming together mine is coming apart
Like that clutch and flywheel, thought you was sticking to single plate? if i have the money i might be changing that on mine as well for 5.25"
Im looking forward to seeing at the fast show! i shall be there and hopefully quicker as i got beaten by a pug that pulled a 12.47!
Didnt you run a 12.2 at USC???
Well its update time. Me and wwmnw cracked on this morning to trial fit the clutch assembly to get the measurements to figure out which hydraulic bearing is needed.
We started by weighting the old clutch and new clutch assembly. You might be suprised at the weight differences.
Old helix paddle clutch assembly and ttv flywheel
new AP clutch and ttv flywheel
Flywheel as it sat on the engine
clutch assembly as it sits on the crank
when we offered the box up and found when the gearbox bolts were nipped up the box fouled the clutch housing
Another
When speaking to steve we have come to the conclusion that running a alloy spacer between the box and block and power filing and touch of the case should do the trick. I have got loads more to update We just ran out of time to take the pics but ill try and do that while I make a template spacer tomorrow.
Cheers Gareth
get the grinder out!!!
As much fun as that would be, it might be a bit harsh
Quite a weight saving there, bet your glad you went for that now, good value for weight lost i think!
How much clearance do you need mate? as in how thick is the spacer going to be?
mike
Posting Permissions
Reply With Quote
