My XE nova on throttle bodies (Project 275+bhp)

[Danny s-p]

Well I picked it back up today looks good for york next sunday feels quick just hope the weather holds

i hop the weather hold's up can't wat to hear it on the strip.

[Gareth_C]

i hop the weather hold's up can't wat to hear it on the strip.

lets hope so mate looking hopeful so far

[Danny s-p]

lets hope so mate looking hopeful so far

get some more pic up

[Gareth_C]

get some more pic up

i will mate get some more at the weekend got my axle back today aswell

[Danny s-p]

gd gd how lindon's v6 going is it reddy for york

[Gareth_C]

gd gd how lindon's v6 going is it reddy for york

looking like it ish you know them too will get finished on sat night

[Danny s-p]

wat it been getting done and am i still coming to york in the bus

[scott.parker]

Dam nice car, love the engine build mate, what power/torque is it at right now?

Scott

[Gareth_C]

Dam nice car, love the engine build mate, what power/torque is it at right now?

Scott

Hi scott the car is producing 265bhp at the flywheel and 200ftlb torque

[Gareth_C]

quite a few people have asked for the engine spec so here goes

QED direct to head throttle bodies
kent very high lift cams
coscast fully ported and polished cylinder head with double valve springs stainless steel one piece 1mm bigger valves
wossner pistons running about 13:1 compression
steel rods
acl lead/copper bearings
autosprint forged steel crank (through choice though)
full arp studs and bolt throughout
TTv one piece billet flywheel
and a 4 paddle helix clutch

If I can think of anything else I will add on