Welcome to the Performance Nova Group forum!
To make full use of the forum, you need to be registered and logged in. Registration is free and allows you to read and post on the forum, and from there you can continue to join the club if you wish.
Originally Posted by Adam Get it machined on a lathe, mine cost £20 at a local engineering place to have done. You got a pic of yours ad, so he can see?
http://www.pngclub.com/forum/showpos...&postcount=972
Old XE track car http://www.pngclub.com/forum/showthread.php?t=74272
I just cut/ground mine to where the pulley starts angling outwards
£10 on a lathe for mine to be done
IT'S NOT A BODGE IT'S JUST BEEN RE'ENGINEERED buyer/seller feed back..CLICK HERE
Forum Rules