I require the cowl that covers the clocks in a mk2 and the plastic part to the right that holds the light swith.
I also need the thin plastic part that covers the heater blower under the scuttle pannel.
I require the cowl that covers the clocks in a mk2 and the plastic part to the right that holds the light swith.
I also need the thin plastic part that covers the heater blower under the scuttle pannel.
Last edited by 16xe_chris; 20-02-09 at 05:44 PM.
i have the plastic part to cover the heater got both bits make me offer
thanks
You have pm
Up ttt again
I also need a mk2 connector the big one that goes into the clocks, must have a decent bit of wire on it so i can re-solder them back to my loom
did you find the other protector?
Not yet mate, my garage is that full of nova and work gear its a joke, need to start getting rid of some stuff
ive got one plastic cover make an offer
Dan you have pm
Bttt
I have the bit that goes over the clocks on a mk2.