Dar's Sprint Car

I cleaned up the discs as well today. They were full of rust and dust. So thought it was a good idea.
From this
http://img.photobucket.com/albums/v4...5ab802129c.jpg

To this
http://img.photobucket.com/albums/v4...e9dc325f19.jpg

I also put in the shafts. Although I am waiting for the equal length one to arrive.
http://img.photobucket.com/albums/v4...f5db67959d.jpghttp://img.photobucket.com/albums/v4...018_170154.jpg

Chris also gave me these
http://img.photobucket.com/albums/v4...018_201005.jpg

Which will make mounting this easier
http://img.photobucket.com/albums/v4...018_201036.jpg

Hopefully not long now until it's working again.

Mmmmm equal shaftage.

Makes me wanna start a flat front floor for mine, you went for plywood dar?

Quote:

---

Originally Posted by BRoadGhost

you went for plywood dar?

---

Yup, a piece of marine ply.

How does it coupe with occasional leaks?

(please don't say with flaming abandon).

Are you waiting on an LMF equal shaft? I ordered one about 2 weeks ago and am also waiting lol

I had no problem with leaks. Don't get me wrong the car leaked, but the splitter was well away from the exhaust. Apart from where the manifold bolts to the rest of the system. I ran it close and then cut the burnt bit away :)

Yup from lfm for the shaft. I am now hoping that they got a few on order from two weeks ago. Mind you at the pace my car is getting developed I don't think a long waiting time is going to be an issue. However I can put the old shaft in if the car is ready for mapping before the shaft arrives.

New drive shaft arrived and fitted. It's nice to have the car rolling again. The front splitter mounting is only temp at the moment.
http://img.photobucket.com/albums/v4..._141734_sm.jpghttp://img.photobucket.com/albums/v4..._145252_sm.jpg

Like the floor.

Fcuk me that floor's low

Quote:

---

Originally Posted by BRoadGhost

Fcuk me that floor's low

---

Inspiring you i hope...