Dan's L reg Td SX

Well I got back from work today at 5.51 and guess what,... I did more work on my car... IN THE SUN :)

I made the wing and the door fit the sill better with the aid of a block and a hammer. Then I preped the wing with 400wet and dry, panel wiped it and sprayed it with grey primer.

What do you think. I think it fits miles better than most original Novas wings do!

https://fbcdn-sphotos-a.akamaihd.net...81093284_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...26157808_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...62616241_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...40678071_n.jpg

Overall I am very pleased with it and plan to do the other side tomorrow.. Good times :)

That is a good gap dude, good going!

Cheers Scott. the door used to stick out nearly 10mm past the door and the wing stuck out a good few mm past the door so overall pretty tidy now :)

that wing looks spot on mate, primer looks really goos to.

Cheers Sam :)

looks good, jealous of your solid battery tray lol I did laugh when you were pointing out those microscopic flaws in the wing though lol

Problem is, it's not a proper Nova now, you should be able to see the panel gaps from space lol

Quote:

---

Originally Posted by Lewis.

looks good, jealous of your solid battery tray lol I did laugh when you were pointing out those microscopic flaws in the wing though lol

Problem is, it's not a proper Nova now, you should be able to see the panel gaps from space lol

---

only bit of the car that is solid!

Well I was ashamed at the lack of effort I have put in recently after seeing Craigs GTE project so I thought I best get my **** in the garage and finally get the wheel Lacquered.

I used 2k Lacquer as I wanted a deep shine,

Here is the results. Not perfect but pretty good I think :)

https://fbcdn-sphotos-a.akamaihd.net...13458462_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...94691100_n.jpg

I have also stripped the long Shaft and found out why it was knocking,


Cleaned up the Tapered shaft.
https://fbcdn-sphotos-a.akamaihd.net...86570613_n.jpg

And the Big block inner.

https://fbcdn-sphotos-a.akamaihd.net...89042219_n.jpg

And here centre of the outer, Looks to be the part at fault!

https://fbcdn-sphotos-a.akamaihd.net...89980191_n.jpg

I have sourced a New outer off Lewis so all is good.

While the Wheels were drying I gave the outer a coat of primer. I will be doing them silver and the shafts black enamal like the rest of the steering/suspension components :)

https://fbcdn-sphotos-a.akamaihd.net...58845751_n.jpg

Any way that is all for tonight.

Wheels look mega.

Wasn't aware I gave you an inner joint lol thought you wanted an outer? and i've not given you that yet lol

Quote:

---

Originally Posted by Lewis.

Wheels look mega.

Wasn't aware I gave you an inner joint lol thought you wanted an outer? and i've not given you that yet lol

---

Corrected, and you will though!!