Steering Column Shear bolt removal.

[Benn]

With the dash fitted. Cant get my drill in the gap, thinking if i belt sand the head off... Tried hammer and chiseling to try and turn it but it doesn't want to move....

Any tips?

[Plug]

I used a hammer and sharp chisel,

if you sand the head off you've still got to try and remove the rest of the bolt

[millworm]

Mine came out with a punch and a chisel, could weld a nut on if out the car or dash out

[House]

Punch and chisel the edge of it round mate, that's what I did!!

[meritlover]

are you turning it the right way?

[Benn]

If i grind the head off, then the thread bit should be lose as the tension is gone... Well in theory..

i started to hit it with a hammer and chisel, i'll try again tonight making sure i hit it the right way.

[findog]

Mig a 13mm nut on it. Spot the inner.

[Benn]

Again dash is in. Not much room to get a torch in there, plus fire risk.

[Novasport]

Punch and chisel. I have got them off with mole grips a few times before.

[Royston]

Mole grips...........small?

Good ones!