possibly breaking my LET nova/sell as project

[AlanH]

i have a K plate nova that started life as a 1.2 expression, has had seam welding, strengthening and 2 new rear arches but arches still need smoothed in. welded in rear brace, modified seat mounts (unfinished) cobra monaco s buckets in red with harnesses, corsa brake servo conversion, gsi dash, bonnet with astra gte vents, spax RSX front coilovers, v6 brakes, -60mm rear springs. LET engine bought from daftjohn with coscast head, has had new headbolts, 3 layer steel cometic head gasket, ARP rod bolts, ph5 wallace performance chips, new dizzy cap/rotor arm, XE inlet, vernier pulley, new clutch on pot type flywheel, new shells etc, turbo has virtually no play. had running very briefly but have removed wiring etc. again and binned old fuel pump, can connect starter up so engine can be seen turning etc. loom is in good cond. and uncut, car wiring is just about complete, just needs tidying up and an ignition live sourced for engine loom, i ran it direct to battery for trial run but can advise where to hook it up etc.. comes with motorsport shafts and big block 4 stud hubs, a set of azev A 15X7.5 rims with no centres/tyres and need a tidy up/paint. Has an f20 box and all conversion mounts, new facet fuel pump still in box, tophat cover, strut brace, iveco truck intercooler, bailey dump valve and loads of other parts i've probably missed. Easy project for someone with the time to finish £1600 NO OFFERS! swap/px track bike or 900 for engine with loom, turbo etc. then will break car. viewing essential and will need to bring wheels to tow it away, sadly i just dont have time or cash to finish pics to follow

[AlanH]

<those are the type of wheels, were lewi007's

<same car, pv 09 with xe in
can get more pics if required but as i say viewing is pretty much essential, i can be contacted on 07956161790

[Plug]

ph5 wallace performance chips - what power do these produce? and what fpr was needed?

[AlanH]

309bhp according to the top of the chip but not sure in real world terms, run 4 bar iirc, comes with adjustable pressure regulator though so can be set to whatever works best. can split ecu to show chips if required

[Plug]

would you sell ecu and adjustable Fpr seperate ?

[AlanH]

No chance mate, whose gonna buy an engine without it? Whole engine only

[fastcar1cars]

Azev are 16" there were mine! Lol!

[AlanH]

Correct. Forgot to add car has polyflex powerbushes, a magnex b/box and clear lights, a gen. gsi front bumper and skirts

[Iain]

Front bumper painted or unpainted?

[Will F]

I would be interested in the bare engine mate (no loom/ecu etc)