Thank's RoystonI've put some photos up on my build thread today.
Thank's Royston
Yeyyy, good to see repair work has started already, i think you need to add a wedge under the throttle pedal so it will only go down a third of the way, and block the linkage so it wont get any gears higher than second
Ive done nothing to mine as yet, drove it on boxing day which was good fun, out down my fave local route (which is also my summer bike ride loop of about 18 miles) got a load of bits to do on it over the next week as im off, just rain is stopping play for now, oh well there is always drink (two bottles of honey jack should keep me occupied)
Originally Posted by Spudly
Yeyyy, good to see repair work has started already, i think you need to add a wedge under the throttle pedal so it will only go down a third of the way, and block the linkage so it wont get any gears higher than second
today i cleaned out the crankcase breather as it ridiculously full of gunge and muck.
Also welded in my harness eyes and did some panel beating
i put a new master cylinder on mine so now i actually have brakes.
it must of been fcucked since i got the car as the brakes have always been terible but now stops instanly
Welding !
i dont have a nova but been alloy welding my iscv plate on my manifold for my zetec turbo and adding vacuum take offs
shag all on nova, but got a rollocking for putting ally swarf all over the kitchen table when playing with my new inlet manifold & my dremel
Sorting out the massacre left in my engine bay from the previous owner!
This is what I had to sort!
How it is at the moment
Started smoothing a few bits off too.
^^that bit of weld fell off when I went to grind it that is how bad his welding was
Last edited by corsapowerr; 29-12-12 at 11:37 PM.
Nothing much production wise but ive been collecting parts and now have ATE front brake set up for the Sprint. Cheers Iain.
Posting Permissions
Reply With Quote
