James you cheeky git! Only thing holding me back is cash. So depending on how much business I can book and how much commision it earns me this next few months will depends if its on the road this summer!
Small update to come when pics upload.
James you cheeky git! Only thing holding me back is cash. So depending on how much business I can book and how much commision it earns me this next few months will depends if its on the road this summer!
Small update to come when pics upload.
Engine bay wiring is basically done for now. I've just got to run the earths for each component (they had to be cut for te rejig), run a wire into the car for the rad fan and main live to starter.
So main loom comes in on the left with also the main live from the battery to the starter...
Wires then run in the scutte for brake reservoir, blower, wiper &washer bottle...
Last edited by The Simps; 17-03-09 at 08:55 PM.
The rest go down the drivers inner wing and under the slam panel with temp switch running down one side and horn, reverse switch & fan the other. Main beam, side lights & indicators now on 1 plug too...
Last edited by The Simps; 17-03-09 at 09:00 PM.
The wires for the back of the engine will all come through here along with loom for the ECU to the EDIS-4 (is only 4 core shielded)...
So all will be nicely hidden away which is one nice advantage of running carbs!
Just got to trim up the rear loom to length then I'll take it all out again to finish off the earths etc.
Last edited by The Simps; 17-03-09 at 09:01 PM.
looking good
SBD also do customs i think mate!Originally Posted by Count Vaux Alot
Looking good, nice work on the loom
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
Very nice, i've taught you well..
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
Cheers for the comments. Its one of those tasks that takes ages and you're spending all the time on something so that people DON'T see it!
H&H don't do the leads, will try SBD then. Cheers Dan.
When i had my bike carbs agessss ago, im sure i remember reading you can use a Ecotec/XE dispak with the EDIS system..... (afterall they are fairly generic 3wire ignition packs, same as edis one)
Which would mean you could keep std leads.
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272