Stupid ass college boy

[Anonymous]

My mate has just put a 57i & a boost valve on. it was all ready chipped. But now it runs like a flamin rev and go moped! it ran a fousand times better wiv just the chip. I said i would aks you guys. So there ya go. Jobs done!

Any feedback would be good too!!

[Anonymous]

dont you think the level of english today is disgusting?

What are you actually asking?



Davo

[Anonymous]

It`ll be fine after a session on some rollers, possibly re-map the chip? It`ll cost more Dollars though!

I think its just this site, coz I`m damn well educated (not braggin) and my english falls to pieces on 'ere! sdf esrgji asd huoh fsd ?

[Anonymous]

I dont think that I will tell him though, because then he will be able to keep up with me :-((

[Anonymous]

i reckon it be the boost valve not set up correctly

[Anonymous]

disconnect battery for a few hours then reconnect and enjoy!!!

[Anonymous]

Will the ECU compensate that much without tinkerin?

[Anonymous]

ste what will takin the battery off do??reset summit??

[Anonymous]

The ECu learns as it goes, and remembers settings and faults. Disconecting its power for a couple of hours will completely drain it, and it`ll start learning from scratch, with all of your mods.

[Anonymous]

Coz the chip will be mapped for the standard set up, a car with a induction kit and or boost value will always be quicker better than a standard car if the products are set up correctly