Hi All,
As part of my conversion, I will have an electronic speedo. The loom is a cut down version on a Zafira B loom (CANBUS). The speedo is driven from the ABS sensors on the car. I have left that wiring on the loom and I need the ABS ECU to avoid issues with the engine running and the speedo.
So I either need a set of Corsa B hubs or do a modification to my drive shafts / hubs to fit a sensor and get a signal.
Info is a little sketchy on pulse outputs and if a Corsa one would work so I am hoping someone could help. Would I be able to use outer Corsa B CV's with the metal ring and mount a sensor? Do the Corsa B CV's fit normal 22 spline driveshafts? (I think 1.6 ones do but not smaller engine sizes)
Is that a sensible route or does anyone have anything they have done before? I am thinking it would be good for when I can afford custom dash and ECU etc.