Results 1 to 8 of 8

Thread: C20let pistons and rods

  1. #1
    Senior User
    Join Date
    Aug 2008
    Location
    blackpool
    Posts
    3,414
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default C20let pistons and rods

    Any one got any standard pistons cheap?

  2. #2
    Senior User
    Join Date
    Sep 2005
    Location
    brotton , saltburn by the sea
    Posts
    1,877
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    What are they for mate

  3. #3
    Senior User
    Join Date
    Aug 2008
    Location
    blackpool
    Posts
    3,414
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    8v turbo build pal.

  4. #4
    Senior User
    Join Date
    Sep 2005
    Location
    brotton , saltburn by the sea
    Posts
    1,877
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    If your only going to run standard pistons why not just run a decomp plate pal .
    If you still havnt got sorted by xmas time give me a message i will have my wossners up forsale cheapish as changing to wiseco 87mm

  5. #5
    Senior User
    Join Date
    Aug 2008
    Location
    blackpool
    Posts
    3,414
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Thought about that and couldn't find a place who does them. Any ideas?cheers

  6. #6
    Senior User
    Join Date
    Sep 2005
    Location
    brotton , saltburn by the sea
    Posts
    1,877
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Ebay £50 mate
    Cheap and cheerful solution if your just looking for low-mid power turbo build
    If you do decide to go for rods aswell i would already have your motor stripped down and check the rod width and the bearing size as im pritty sure there is two different width bearing set ups someone will correct me if im wrong but im sure they are something like 19.5mm and 20.3mm .
    Last edited by total_vauxhall; 24-09-20 at 10:15 PM.

  7. #7
    Senior User
    Join Date
    Aug 2008
    Location
    blackpool
    Posts
    3,414
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Cheers pal. I've already stripped it down pal so will check. I might just go down the decomp plate for the time being.

  8. #8
    Senior User
    Join Date
    Aug 2008
    Location
    blackpool
    Posts
    3,414
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Still need a set.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •