i would like the engine or shell sold first,before i take anything off the car
engine
• 1998 Rebuilt C20LET
engine, covered approx 8,000 miles, ported and polished Coscoast cylinder head, arp head stud kit and arp rod bolts, duel layered steel head gasket, xe inlet cam, ngk plugs, 8.5mm magecor leads, full roose/samco hose kit in blue, paddle clutch brand new, pot type lightened flywheel, front mount including 2.5” hard pipe kit with hoses and clamps,up rated oil cooler, radiator, fan. Owen Developments GT2860rs turbo, Nortech manifold, Turbosmart 38mm racing external wastegate and screamer pipe, with fixings – (all new in may 2008, receipts total £1807.16) - covered approx 4,000 miles –has just had new cambelt kit (gates one) and water pump,also custom inlet manifold made by(novarick) has a v6 throttle body on,has mbe 941 ecu,needs map sensor(but i will get one to supply) and its got a sbd coilpack and qed blaniking plate,needs mapping and got a spare let loom if needed(some plugs are missing due to making mbe loom up) 2000 ono
can't be heard running as not on right base map !!!
http://i207.photobucket.com/albums/b...4122010243.jpg
f28 box with quaife diff,no crunches or wines,just had two driveshaft oil seals fitted by 700
http://i207.photobucket.com/albums/b...va/photo-5.jpg
also got a side exit exhaust for this turbo setup 150
apexi boost controller 350
http://i207.photobucket.com/albums/b...4122010245.jpg
revolution rl7 wheels 15" got 5 of them 400
gaz coilovers never seen the road 300
eccentric topmounts (are off djbrowneys nova)100
cav internal shifter 30
rosejointed linkage 35
wilwood midilites 300
dd2 digi dash with all sensors for it 400
http://i207.photobucket.com/albums/b...4122010244.jpg
quaife quick rack 100
strengthend bottom arms 40(benn has name on these)
rally design bias pedal box120
braided brakelines 60
equal legnth driveshaft setup,with m-tec shaft,new cv joints 200
rear disc beam 120
big block hubs the propper ones 280
chris astley solid engine mounts,including f28 mount 120
strengthend rear gearbox mount,done by paul 30
now the shell
The shell is a 1.2 sxi 1992 on a k plate
It's got front strengthening plates welded on and seam welded around the front and strut tops,boot floor has been cut and and a plate made up and welded in,had to new front arches the rears are mint,still the original ones,front crossmember has been cut to allow for intercooler,also the slam panel had been cut to for easier access,the car has been painted inside and out ford moonstone blue,there's a little rust patch that I found in the boot on the tight hand side usual place,got glass windows alround
want 700 with the rollcage omp or can do a deal is hair want a rolling shell
ive got no v5 for this but will pay to get a v62 if needed cheers
or will sell the car as one for the right offer
contact me on
07572421794 
