-
cavs boost sorted
-
-
-
works ok abit laggy in comparison to the k16 and im not sure about the screamer pipe either(bit in your face for a daily)
On a whole fairly pleased and kicks in hard but smooth so im happy cant wait to get a new map done for it now
-
Looking nice, What sort of power where you running before? What you after?
-
Lmfao, i knew youd do it, and i told Claire you would aswell haha, good lad:thumb:
-
now if that dont make 300bhp i think mr porter will be rather pissed of lol
-
When is she getting Re-mapped?
-
Will be soon id think, from what he was saying to me the other night on the phone, he has struck up a deal with the guys who had the mobile rollers @ pod and they are going to work their wonders on it for him:thumb:
-
Oh spot on, sounds good to me :)
-
i like looking at a LET in its rightful home :)
-
-
when it spools it sounds like a jet starting up the noise on let of is infectious.
it made 269.9 so 270 brake with slipping clutch and water leak, but it would not hold boost at the level i wanted (22 -24 psi) it would hit 22 momentarily then drop to 16 and it didnt matter what we did it would not hold any more!
This on the other hand while setting it up,bent the needle on my boost gauge earlier and it only goes to 26psi. Best bit is the afr was still not leaning out lol
Set it up at the minute to hold a respectable 20psi but as spud said it will be getting more custom written chips ect soon with mild anti lag ect maped in and fingers crossed around 360-370 horse hopefully.
The guys with the rollers claimed that if it was capable of holding its peek then it would have been well in excess of 300 as it was. when its maped i will be aiming for about 28psi so about 2bar hopefully
