what is the best way to take the wheel well out and how do i make it smooothe
Printable View
what is the best way to take the wheel well out and how do i make it smooothe
my guess would be to angle:twisted:grind the b*****d :twisted: out then weld in a sheet of the correct size...
would the back end need strengthening
or should this be ok with just a sheet across
like this, as it give you more strength
http://www.lindborg.me.uk/Stuart/104CANON/IMG_0454.JPG
im using a single skin of fibre glass over the top
got any more pics
nope
where does the other side join on to
its an X between the two chassis rails. the bit you cant see is almost at the very end of the rails at the rear.
see my previous post.
and THINK about it!!!