Just MIG...
Printable View
Just MIG...
Good work on the brake lines.
Sorted all my brake lines now, just need some banjos for the rear drums. Lots of pics as I appreciate feedback or concerns with how I've done it!
http://iainel.co.uk/images/forums/NovaWIP2/733.JPG
Replaced the shaped metal (originally for the brake pedal?) with a flat piece so the t-piece sits further back and so makes more room in the bay. Will make a tidy one before refitting:
http://iainel.co.uk/images/forums/NovaWIP2/734.JPG
Each side coming off the t-piece utilise the standard bracket and mate to Goodridge flexis:
http://iainel.co.uk/images/forums/NovaWIP2/735.JPG
http://iainel.co.uk/images/forums/NovaWIP2/736.JPG
Runs down the centre inside:
http://iainel.co.uk/images/forums/NovaWIP2/737.JPG
And under the gear shifter (will make a small hole for it to pass through when fitting the shifter):
http://iainel.co.uk/images/forums/NovaWIP2/738.JPG
Single flexi to the rear beam:
http://iainel.co.uk/images/forums/NovaWIP2/739.JPG
And uses the original tabs on the beam:
http://iainel.co.uk/images/forums/NovaWIP2/740.JPG
Just not sure where to mount my bias valve now though. Thinking either here:
http://iainel.co.uk/images/forums/NovaWIP2/741.JPG
Or here:
http://iainel.co.uk/images/forums/NovaWIP2/742.JPG
Suggestions?
Looking good. Id mount it by the handbrake
Yep, definately by the handbrake. Lines look good Iain..
Cheers, yeah they look nice, whether they work/leak is another matter though. lol
Another vote of by the handbrake from me as you will want it accessible from your seat rather than having to test your bias amount then get out and lean in the back from the boot and adjust it, more good looking work as always lionel keep it up:thumb:
As said before, thats a LOT of joins to leak :p lol
Fingers crossed they'll be sound though :)
As spudly said :thumb: Lines look good, something I quite fancy doing on the yellow one as I want to go with corsa set up too...
Ive just looked at all 91 pages lol
Top work mate,honestly !!!!!!!!!!!! :thumb: