my nova project (volume 2)

Quote:

---

Originally Posted by yayoboy

thanks m8, just got a brand new delco one anyway now m8, place in nethey had one in stock. when its done feel free to come and have a nose, whre you work not grifford?!?

---

kool just give me a pm when its done lol nana i work dow kinver at little independent garage

got this today
http://i7.photobucket.com/albums/y29...3092009651.jpg

http://i7.photobucket.com/albums/y29...3092009654.jpg

think it looks quite good and is good quailty too. tryin to sort out my teflon brake hoses next and then get the exhaust done, then its time for a trip to the rollin road to have the initial setup!

Hey mate that looks good, where did you get it because im thinking about getting one ?

just found it on ebay, is a newton equipment one
http://newton-equipment.com/

Looks more like the Novatec one's

talked about this on another thread, i think the novatech, newton and tweeks ones are all the same. but mines in definetly newton, pt no is stamped on the back of it

picked up these off john h today, easiest place to store it for now is were it should be lol, ive now got 2 sets of gsi bumpers one bnib (scared to use them lol) and these which i think are virtually new, cheers john:thumb:
http://i7.photobucket.com/albums/y29...8092009662.jpg

also stared fitted my bias box, fetching the teflon hose and fittings tomorrow, btw whats the fitting thread size for the rear drums?

http://i7.photobucket.com/albums/y29...8092009660.jpg

got these today
http://i7.photobucket.com/albums/y29...9092009665.jpg

and started making my lines up ;)

http://i7.photobucket.com/albums/y29...9092009671.jpg
http://i7.photobucket.com/albums/y29...9092009670.jpg
http://i7.photobucket.com/albums/y29...9092009667.jpg

only done drivers side for now, will get rest done weekend now, back on shifts :cry:

sorry for no updates for a while, been busy finishing it off. well, its all done and on the road now, got it mot'd taxed insured and re registered as a 2.1 over the weekend and today, drove it for about 40 mile today and it was sweet as a nut!! will get some pics up in the next couple of days of the 'finished' article. just want to get some miles on it now so it can go on the rollers for the power run! this stage is complete, the bodywork project will start early summer!!

I hope your upgrading thay 256 brakes with that engine spec