Dan's L reg Td SX

sill ends are always cunts :( remember mine? :cry::cry: which is why cookie had to put 3 tons of filler in them lol

wow this looks so good nice work your o/s engine mount holding up still

Thanks Dude, Yeah mount did a further 3000 miles and is still hanging in there :)

Well me and Cookie cracked on first thing, he set about the sill and I did removed the Column, Pedal box and heater box.

https://fbcdn-sphotos-a.akamaihd.net...93266297_n.jpg

The sill that Cookie fitted.

https://fbcdn-sphotos-a.akamaihd.net...17683522_n.jpg

We then set about aligning the panels and drilling the new holes for the wing..

Door gap, very happy with this :)

https://fbcdn-sphotos-a.akamaihd.net...62294603_n.jpg

Its the best its ever been..

https://fbcdn-sphotos-a.akamaihd.net...64318340_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...13508047_n.jpg

https://fbcdn-sphotos-a.akamaihd.net...30426966_n.jpg

The sill isn't fully welded as I still have to do a bit to the inner wing/sill end.

https://fbcdn-sphotos-a.akamaihd.net...23145038_n.jpg

I then removed the full car loom, wow there heavy lol.

https://fbcdn-sphotos-a.akamaihd.net...65733653_n.jpg

Cookie went home and I carried on welding, so I welded the back of the plates I had put in around the front inner wing and sill.

https://fbcdn-sphotos-a.akamaihd.net...52858364_n.jpg

Very strong now.

https://fbcdn-sphotos-a.akamaihd.net...15969849_n.jpg

Wire wheeled it down and gave it some etch primer.

https://fbcdn-sphotos-a.akamaihd.net...22376552_n.jpg

Once all the welding is done I intend to do the hole car, inside and out.

Welded up the lock hole.

https://fbcdn-sphotos-a.akamaihd.net...35329407_n.jpg

And how I left it for the night.

https://fbcdn-sphotos-a.akamaihd.net...08538439_n.jpg

Tis looking good

https://fbcdn-sphotos-a.akamaihd.net...08393408_n.jpg

Dan

I thought this looked clean at Billing this year if I'm thinking of the right car, excellent fab skills though

Thank you Graeme, yeah she looked nice for billing, even got a little shot Total Vauxhall. I new the chassis legs wanted doing and the arches wern't the best but I didnt think it was anywhere near as bad as this. Never mind though as I am enjoying doing it :)

looking good :) what's left then?
I recognise that gear knob too lol

More good work fella, where the **** do you get the time to do all this lol

Lewis. well it wants the o/s inner rear arch sinishing, the the O/s reaar arch fitting, A back panel, N/s sill, N/s/ rear Inner arch and outer. N/s/f inner arch, torret top wants cleaning up as its been plated badly. Front cross memember finshing, both front chassis legs and floor. then wiring wheeling, Zinc primeing the hole car, sealing, painting.. There is about 40hr of welding left yet lmao.

Well Kev, I have decided to dtay single until the build is complete! lmao

Thanks guys