I would like to run a dash bar across, but also want to keep the dash, it wont fit behind the dash, is too high above the dash and just not feasible beneath the dash, so think im sh!t out of luck there :(
Printable View
I would like to run a dash bar across, but also want to keep the dash, it wont fit behind the dash, is too high above the dash and just not feasible beneath the dash, so think im sh!t out of luck there :(
No probs kev give me a call closer to the time.
Paul
Will the dash bar not fit sat right up against the bulkhead welded to the front triangulation bits? As this is where an spi loom runs and they're not exactly small.
looking good buddy :)
Shame the cage didn't use the wiring loom hole I cut out lol
Looking good as per normal :)
So been down the breakers this morning, got a new pair of lower arms, another heater matrix and some saab reds for the XE...
Xe on reds?
Must be running some power, or low pressure?
TBs, so about 200ish bhp.
Welding looks sound!
Don't hang about do you Paul! Took me weeks to triangulate the front lol
Dash bar hmm, could drill off the inner skin to gain more room but you're losing the box section so seems a bit silly.