My RWD C20XE Chevette build

I also thought the brackets looked wrong but if you think they are right then fair enough.

look at this pic and please advise me.,

body work at the top, wth the top bracket welded to it....

http://i30.photobucket.com/albums/c3...9b19d2ca-1.jpg

In my opinion, it should look like this:
http://www.xen0phobiak.f2s.com/bmwhanger.jpg

That way its less likely to slide out when cornering.

ahhhh i see.

yes you are correct, as the weight of the exhaust is pushing down etc etc.

i shall bend them the other way tonight.

thanks alot :D

No problem.

much better!

ok done a small amount of work, im stacking up the work, as im on holiday soon so gonna do the work on the car in the daylight hours!

some anti roll bar brackets for the rear, going to be welded to the car.

http://i30.photobucket.com/albums/c3...6/92143738.jpg

http://i30.photobucket.com/albums/c3...6/45d81837.jpg

also got this of someone on here, (not sure if im gonna use it yet, but probably)

http://i30.photobucket.com/albums/c3...6/c9382c8f.jpg

had a tinkle with it.

http://i30.photobucket.com/albums/c3...6/26b1b1d6.jpg

http://i30.photobucket.com/albums/c3...6/a1999eae.jpg

ok a small update. just preparing for my week off in a few weeks.

had a gamble on a set of calibra braided hoses.

http://i30.photobucket.com/albums/c3...6/cd508ae0.jpg

came up trumps, win

http://i30.photobucket.com/albums/c3...6/4c6fecd1.jpg

should have the brakes finished soon.

screw the ats's slap the turbines on it lol

FLOL,
thanks dude,
the offset would be to low i think, but i will give them a try!