get it test fitted dude!!
Printable View
get it test fitted dude!!
Right fitting.
Sat on the cut out,
http://img.photobucket.com/albums/v3...tercooler3.jpg
Ends from the out side,
http://img.photobucket.com/albums/v3...tercooler4.jpg
From the in, should be ok with either an rubber elbow or a welded on elbow.
http://img.photobucket.com/albums/v3...ercooler13.jpg
Looking down, you can see its behind the line from the irons.
http://img.photobucket.com/albums/v3...tercooler6.jpg
Bit tight on the bumper, will shave a bit from the mouth and a lil more from the front pannel (see pic 3down)
http://img.photobucket.com/albums/v3...tercooler7.jpg
Sitting right behind the cut out of the mouth.
http://img.photobucket.com/albums/v3...ercooler11.jpg
Need to strighten this line up a bit, then it will fit a lil better.
http://img.photobucket.com/albums/v3...tercooler8.jpg
:)
I love it when a plan comes together!
if you trim the side flaps you'll easilly get some chopped down 90s in there without needing to weld the end tanks
Looks like it may work mate! are you going to run an f28? is so, make sure the elbow from the cooler to the tb will clear the f28 box mount!
Where'd you source the i/c benn?
Looking good Benn
Si: Theres enough room i think they will fit, but will if needed.
Dan: May work? Hope it will. Get on msn. No F20 for the mo.
John: Ebay, pm me for the link, hes got a really good shop.
Ad: Cheers. You want the link too? For yours. lol
Aye ;)
Any pics of the cutout in your crossmember?
Yes go back a page.. theres loads...lol