Make sure you take the tappets apart and clean them out(when you get to that point)
Printable View
Make sure you take the tappets apart and clean them out(when you get to that point)
yeh i read this before, how do you get them apart, as i had a go at pulling the middle bit out but it wouldn't budge.Quote:
Originally Posted by Benn
and the ones i have had surface rust on the outside and i am probably gonna replace them. and just soak the new ones in oil.
Tap them down wards on a bit of rag on a bit of wood, will hurt your hand doing it but they will pop out.
Looks good dude :thumb:
i have given up trying to find none noisy one now and just fit some from a late eco tek so much better :thumb:Quote:
Originally Posted by Benn
Quote:
Originally Posted by djbrowney
oooooooo can you get me a link for some please, maybe ebay.
or an engine code :)
Just take them apart and clean them...Quote:
Originally Posted by djbrowney
not a lot of use when you take them apart and find that some are broken :thumb:Quote:
Originally Posted by Benn
You broke some? Wow never seen that before...
you have never cleaned them properly before then, by pushing the ball in the tappet which is sprung loaded, if the ball dosnt pop back out its ****ed :pQuote:
Originally Posted by Benn