should be about mate yeah!
My shed is near acle - are you allowed to wonder that far?
Printable View
should be about mate yeah!
My shed is near acle - are you allowed to wonder that far?
1000 miles a week im sure there not going to miss another 15 lol
Some work your putting into that fella, should be cracking when done :thumb:
So I didn't get as much time today as I wanted but I got the plate tacked in. The fit isn't bad and I always new it was gonna need lots of filler work! lol
The pics...
http://img.photobucket.com/albums/v3.../07-05-092.jpg
http://img.photobucket.com/albums/v3...t/07-05-09.jpg
Looking good.
work looks good:thumb:
Welded on the outside of the back lip then ground it back. I'm finding now my welder control is better I'm leaving the heat on "2-max" for everything and just adjusting wiring speed to suit. There were places I blew thru (expected) but I got some really nice runs along this edge which was pleasing as it was pi$$ thin! My trigger fingers aches like hell now tho. I've got a slight gap (end closest in the pic) but I'll fill that with filler.
http://img.photobucket.com/albums/v3.../08-05-094.jpg
http://img.photobucket.com/albums/v3.../08-05-095.jpg
And speaking of filler...
http://img.photobucket.com/albums/v3...t/08-05-09.jpg
I know have the job I HATE of sanding, filling, sanding, filling, getting bored!
:(
keep at the good work pal. . . is that dolphin glaze you use for the filler?
dolphin glaze??
was just an old tub off filler I had lying around.
Looks good. As does your welding! Yeah, sanding and filling does get abit boring. Worth it though when you get a good finish.