-
Had a few hours to do alittle more prepping. Stripped down the servo and that's ready to paint. Gave the servo mount a quick wire wheel too, (doubt it will stay looking like this for long). Also made a start on the mounts, realised the small front drivers mount is too perished so will need replacing, the larger one that attaches to the engine is missing so will have to find one.
Managed to remove the rear mount after some work and the rubber on that has also seen better days so will be replaced.
http://i1050.photobucket.com/albums/...psw2wkajxx.jpg
http://i1050.photobucket.com/albums/...psbnh6antv.jpg
-
-
Picked up a clarke mig yesterday so can start filling some of the holes on this!
-
-
Coming along nicely mate, good work!
-
The hard work of putting it back together begins now!!
-
Its a nice job though - good luck with the welding. I take my hat off to you for rolling your sleeves up and cracking on!
-
Take the rubber seal from the m\c out and clean it and behind it. Loads of shite builds up in there causing leaks.
http://i1050.photobucket.com/albums/...psw2wkajxx.jpg
-
Thought I'd upload a few pics of yesterday's work. Basically grinding out the rusty floor patches and flapping it back to bare metal plus also tidying up the previous welding around the bay.
Sent from my iPhone using Tapatalk
-
Mk2 Breeze Blue project
