Get the steering knuckles machined to accept the larger vw bearing
Printable View
Get the steering knuckles machined to accept the larger vw bearing
im running Dars old shafts which still use the smaller standard nova hubs.
If he couldnt break them i wont as nowere near the power he is running.
Power doesn't break them.
Interesting mod...i take it that bearing would accept the big block hub straight from a cav etc? Or am i wrong? :confused:Quote:
Originally Posted by BRoadGhost
Yup, but the hub does need a bit of machining as well, well mine did. But only so that you can press the hub all the way in to the bearing without catching on the bearing carrier.Quote:
Originally Posted by Count Vaux Alot
back to the pics oli,nice photos and report,some awsome motors out there,wouldnt mind just going to see one of these days out with the little lad,would be pretty:cool: my fave car of the pics is this one, and a sweet photo you took of it too.:thumb:
PS did it run?
http://i41.photobucket.com/albums/e2...203resized.jpg
Some reet accidents lol
What happend to the black Corsa lol and the silver Audi?
^ Sincerely doubt that 3 door went anywhere the track TBH!
Cheers dude! It didn't run, was just sat in the car park looking sexy!Quote:
Originally Posted by twistysnovagte
I haven't had no fault with machined hubs, however I pressed mine in slowly and didn't hit them in with a hammer etc etc.
Idd some of the length needs taking off the drive flange also.